XCM Xbox 360 Controller Mod Help?
I was building a controller for my buddy with the Blue Blood XCM Xbox 360 Controller shell and lighting mod. I disassembled everything and put the RT and LT buttons on then soldered the wires. I put the controller back together (without putting the screws in) and put on a rechargeable battery pack to make sure the LED’s work, and they didn’t. The circle of light turned on as if it were a regular controller but even if I pressed the “light” button they still did not turn on. I soldered the wires in the correct places (as well as I can tell) but in the instruction picture it is an older style controller and I was modding a newer style. Any troubleshooting ideas? Any soldering tips? Should I just try it with an old style controller?
Here’s instructions from xcm for the newer controller.
http://xcm.cc/install_the_xcm_controller_shell_to_new_360_wireless_controller_shell.3.htm
Here’s for the older controller
http://xcm.cc/wireless11.jpg
I’ve heard on some controllers you’ll need an add on board to get the desired results. Xcm says to contact the seller and tell them you need the add on and it’s free. Here’s a picture of it and how to install it.
http://xcm.cc/add_on_component.htm
Check all your wires first, wires like to get pinched by the dpad, let me know how it goes.
Xbox 360 Controller LED Mod. NO SOLDERING NEEDED!
[phpbay]xbox 360 mod, 200, “”, “”[/phpbay]
Related posts: